SFI System: Precaution

INITIALIZATION

NOTE:

When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.

SYSTEM REFERENCE

System Name	See procedure
Power Window Control System	INITIALIZATION
Sliding Roof System (for Standard)	INITIALIZATION
Sliding Roof System (for Multi-panel Moon Roof)	INITIALIZATION
Lighting System (Adaptive Front-lighting System)	INITIALIZATION
Power Back Door System	INITIALIZATION
Power Door Lock Control System	INITIALIZATION
Back Door Closer System	INITIALIZATION
Electrical Back Door Outside Handle System	INITIALIZATION

NOTE:

Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See INITIALIZATION ).
Perform REGISTRATION (VIN registration) when replacing the ECM (See REGISTRATION ).

HINT:

Initialization cannot be completed by only removing the battery.

FOR USING INTELLIGENT TESTER
CAUTION:
Observe the following items for safety reasons:
- Before using the tester, read the instruction manual.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.
FOR USING BATTERY DURING INSPECTION
1. While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.