Brake Actuator: Disposal

DISPOSE OF BRAKE ACTUATOR ASSEMBLY
1. Using a drill, slowly make a hole at the circumference made by the center points of A and discharge the gas.
  CAUTION: Be sure to wear protective glasses to protect from fragments that may become airborne due to high pressure.
  
  Fig 1: Drilling Hole At Circumference
  Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
  
  HINT:
  - The hole may be drilled up to approximately 5 to 10 mm (0.20 to 0.39 in.) away from the point indicated by A without problem.
  - The gas is nitrogen, which is colorless, odorless, and harmless.