Monitor Result
Refer to CHECKING MONITOR STATUS .
The test value and test limit information are described as shown in the following table. Check the monitor result and test values after performing the monitor drive pattern (refer to "READINESS MONITOR DRIVE PATTERN ").
- MID (Monitor Identification Data) is assigned to each emissions-related component.
- TID (Test Identification Data) is assigned to each test value.
- Scaling is used to calculate the test value indicated on generic OBD II scan tools.
SCALING DESCRIPTION
| MID | TID | Scaling | Description |
|---|---|---|---|
| $3D | $CB | Multiply by 0.001 {kPa} | Test value for vacuum pump OFF stuck (P2401) |
| $CD | Multiply by 0.001 {kPa} | Test value for vacuum pump ON stuck (P2402) | |
| $CE | Multiply by 0.001 {kPa} | Test value for vent valve OFF stuck (P2420) | |
| $CF | Multiply by 0.001 {kPa} | Test value for vent valve ON stuck (P2419) | |
| $D0 | Multiply by 0.001 {kPa} | Test value for reference orifice low-flow (P043E) | |
| $D1 | Multiply by 0.001 {kPa} | Test value for reference orifice high-flow (P043F) | |
| $D4 | Multiply by 0.001 {kPa} | Test value for purge VSV close stuck (P0441) | |
| $D5 | Multiply by 0.001 {kPa} | Test value for purge VSV open stuck (P0441) | |
| $D7 | Multiply by 0.001 {kPa} | Test value for purge flow insufficient (P0441) | |
| $D8 | Multiply by 0.001 {kPa} | Test value for canister small leak (P1420) | |
| $D9 | Multiply by 0.001 {kPa} | Test value for canister gross leak (P1421) | |
| $DA | Multiply by 0.001 {kPa} | Test value for fuel tank small leak (P1422) | |
| $DB | Multiply by 0.001 {kPa} | Test value for fuel tank gross leak (P1423) | |
| $DC | Multiply by 0.001 {kPa} | Test value for fuel vapor-containment valve close stuck (P2451) | |
| $DD | Multiply by 0.001 {kPa} | Test value for fuel vapor-containment valve open stuck (P2450) |