Fuel Pump: Installation

INSTALL FUEL PUMP AND SENDER GAUGE ASSEMBLY
1. Install a new gasket to the fuel suction plate.
2. Connect the fuel sub-suction hose to the fuel return jet tube.
3. Attach the fuel pump and sender gauge to the fuel tank.
  
  Fig 1: Identifying Fuel Sub-Suction Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL TANK VENT TUBE SET PLATE
1. Install the set plate with the 8 bolts.
  Torque: 6.0 N*m (61 kgf*cm, 52 in.*lbf)
INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
1. Attach the fuel tube connector to the port of the fuel suction plate.
2. Install the tube joint clip.
3. Connect the fuel pump connector.
  
  Fig 2: Attaching Fuel Tube Connector To Port Of Fuel Suction Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK FOR FUEL LEAKS
1. Start the engine, and check that there are no fuel leaks after performing maintenance anywhere on the system.
INSTALL REAR FLOOR NO. 2 SERVICE HOLE COVER
1. Install the service hole cover with the 3 cap nuts.
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )

Fig 3: Locating Service Hole Cover With Cap Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002