Rear Seat Outer Belt Assembly: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the Standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL REAR SEAT OUTER BELT ASSEMBLY 
   1. Install the seat belt with the 2 bolts.

      Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf) for upper bolt 

      42 N*m (428 kgf*cm, 31 ft.*lbf) for lower bolt 

   2. Install the floor anchor with the bolt.

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) for lower bolt 

      NOTE: Make sure that the anchor part does not run onto the protruding part.
   3. With the belt installed, check that the belt locks when it is pulled out quickly.
      NOTE: The check should be performed with the outer belt installed.

      If the operation is not as specified, replace the belt.

      Fig 1: Identifying Protruding Part Of Floor Anchor

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER FRONT 
   1. Install the luggage compartment trim cover with the 12 clips.
   2. Install the tonneau cover with the 2 nuts.
   3. Attach the 2 caps.
      Fig 2: Identifying Luggage Compartment Trim Cover Clips

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL REAR SEAT BACK BOARD 
   1. Install the seatback board with the 2 clips.
      Fig 3: Identifying Rear Seatback Board Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Install the bolt.
4. INSTALL REAR SEATBACK ASSEMBLY (See  DISASSEMBLY  ) 
5. INSTALL REAR SEAT HEADREST ASSEMBLY (See  DISASSEMBLY  ) 
6. INSTALL REAR SEAT HEADREST PLATE (See  INSTALLATION  ) 
7. INSTALL WIND DEFLECTOR BOARD ASSEMBLY (See  INSTALLATION  ) 
8. INSTALL REAR SEAT HEADREST PLATE COVER (See  INSTALLATION  ) 
9. REMOVE REAR SEAT CUSHION ASSEMBLY (See  INSTALLATION  ) 
10. INSTALL TONNEAU COVER ASSEMBLY