Inspection Procedure

HINT:

Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Warm up the engine.
Turn the ignition switch OFF.
Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.

Follow the instructions on the tester and read the DATA LIST.

ECM:

ITEM MEASUREMENT NORMAL CONDITION CHART

Item	Measurement Item/ Range (Display)	Normal Condition	Diagnostic Note
AT FLUID TEMP	ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F)	After stall test: Approximately 80°C (176°F) Equal to ambient temperature while engine is cold	If value is -40°C (-40°F) or 150°C (302°F), ATF temperature sensor circuit is open or short circuit

HINT:

When DTC P0712 is output and the intelligent tester output is 150°C (302°F) or more, there is a short circuit.
When DTC P0713 is output and the intelligent tester output is -40°C (-40°F), there is an open circuit. Measure the resistance between terminal OIL (OT) and the body ground.

TEMPERATURE DISPLAYED MALFUNCTION SPECIFIED CONDITION

Temperature Displayed	Malfunction
-40°C (-40°F)	Open circuit
150°C (302°F) or more	Short circuit

HINT:

If a circuit related to the ATF temperature sensor becomes open, P0713 is set in approximately 0.5 seconds.
It is not necessary to inspect the circuit when P0711 is set.

CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0711)

Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.

Read the DTCs using the intelligent tester.

Result

RESULT REFERENCE CHART

Display (DTC output)	Proceed to
Only P0711 is output	A
P0711 and other DTCs are output	B

HINT:

If any other codes besides P0711 are output, perform troubleshooting for those DTCs first.

B: GO TO DTC CHART

A: Go to Next Step

CHECK TRANSMISSION FLUID LEVEL
OK: Automatic transmission fluid level is correct.

NG: ADD FLUID

OK: REPAIR OR REPLACE TRANSMISSION WIRE