April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Speed Sensor: Inspection

INSPECT FRONT SPEED SENSOR

Inspect the front speed sensor. If any of the following occurs, replace the front speed sensor with a new one:
- The surface of the front speed sensor is cracked, dented, or chipped off.
- The connector or wire harness is scratched, cracked, or damaged.
- The front speed sensor has been dropped.
  
  Fig 1: Locating Front Speed Sensor With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard resistance:

RH

STANDARD RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
1 (FR+) - 2 (FR-)	Always	1.4 to 1.8 kΩ at 20°C (68°F)
1 (FR+) - Body ground	Always	10 kΩ or higher
2 (FR-) - Body ground	Always	10 kΩ or higher

LH

STANDARD RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
1 (FL+) - 2 (FL-)	Always	1.4 to 1.8 kΩ at 20°C (68°F)
1 (FL+) - Body ground	Always	10 kΩ or higher
2 (FL-) - Body ground	Always	10 kΩ or higher

Fig 2: Inspecting Front Speed Sensor

G04978023

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the value is not as specified, replace the front speed sensor.