Engine Control System - System & Component Testing, Removal, Inspection & Installation: ECM: Installation

INSTALL ECM
1. Install the ECM bracket with the 4 screws.
  Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf)
  
  Fig 1: Locating ECM Brackets And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Connect the 2 ECM connectors.
  NOTE: When connecting the connector, make sure that dirt, water and other foreign matter do not become stuck between the connector and other parts.
  1. Connect the 2 ECM connectors and lower the 2 levers.
    NOTE: Make sure that the 2 levers are securely lowered.
    
    Fig 2: Locating ECM Connectors Levers
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the ECM with the 3 nuts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
INSTALL FRONT SUSPENSION UPPER CENTER BRACE (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )

Fig 3: Locating ECM Fasteners
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).