Inspection Procedure

1. Turn the engine switch off.
2. Disconnect the skid control ECU connector.
3. Measure the resistance according to the value (s) in the table below.

   Resistance 

   RESISTANCE REFERENCE CHART
   
   

   Tester Connection	Specified Condition
   A13-25 (TS) - K16-12 (TS)	Below 1 Ω

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Checking Harness And Connector (Skid Control ECU To DLC3 (TS))

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Measure the resistance according to the value (s) in the table below.

   Resistance 

   RESISTANCE REFERENCE CHART
   
   

   Tester Connection	Specified Condition
   K16-4 (CG) - Body ground	Below 1 Ω

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Checking Harness And Connector (DLC3 (CG) To Body Ground)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Measure the resistance according to the value (s) in the table below.

   Resistance 

   RESISTANCE REFERENCE CHART
   
   

   Tester Connection	Specified Condition
   K16-12 (TS) - Body ground	10 kΩ or higher

   HINT:

   If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (see PROBLEM SYMPTOMS TABLE  ).

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 3: Checking Harness And Connector (DLC3 (TS) To Body Ground)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : REPLACE SKID CONTROL ECU