Inspection Procedure

1. Disconnect the connector of pattern select switch.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Specified Condition
   3 - Body ground	Below 1 Ω

Fig 1: Identifying Terminals Of J36 Pattern Select Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to Next Step 

1. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Switch Condition	Tester Connection	Specified Condition
   Pattern select switch (PWR)	3 - 7	Below 1 Ω
   Pattern select switch (NORM)	↑	10 kΩ or higher

Fig 2: Identifying Terminals Of J36 Pattern Select Switch Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE PATTERN SELECT SWITCH ASSEMBLY 

OK: Go to Next Step 

1. Connect the connector of pattern select switch.
2. Disconnect the cowl side junction block (main body ECU RH) connector.
3. Measure the resistance between terminal PWR of the cowl side junction block (main body ECU RH) and body ground.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Switch Condition	Tester Connection	Specified Condition
   Pattern select switch (PWR)	J75 -18 (PWR) - Body ground	Below 1 Ω
   Pattern select switch (NORM)	↑	10 kΩ or higher

Fig 3: Identifying Terminals Of Cowl Side Junction Block Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE