Front Speed Sensor: Installation

INSTALL FRONT SPEED SENSOR
1. Wipe off sealant attached to the front speed sensor's fitting surface with a non-residue solvent.
  NOTE: Prevent foreign matter from attaching to the sensor rotor.
2. Install a new front speed sensor to the hub and bearing assembly The front speed sensor connector should be positioned upward
  
  Fig 1: Identifying Front Speed Sensor Connector Should Be Positioned Upward
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, install the front speed sensor onto the front axle hub and bearing
  SST 09214-76011
  NOTE:
  - Keep the front speed sensor away from magnets.
  - Do not use a hammer on the front speed sensor.
  - Check that there is no foreign matter such as iron chips on the front speed sensor's detecting portion.
  - Slowly press the front speed sensor straight.
    
    Fig 2: Identifying Skid Control Sensor
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT AXLE HUB SUB-ASSEMBLY WITH FRONT SPEED SENSOR (See INSTALLATION )
INSPECT FRONT AXLE HUB BEARING FOR LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT FRONT AXLE HUB FOR RUNOUT (See ON-VEHICLE INSPECTION )
INSTALL FRONT DISC (See INSTALLATION )
INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY (See INSTALLATION )
CONNECT FRONT SPEED SENSOR WIRE
1. Connect the front speed sensor wire to the front speed sensor.
  NOTE: Do not twist the sensor wire.
INSTALL FRONT WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)

Fig 3: Connecting Front Speed Sensor Wire To Front Speed Sensor
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
CHECK FOR SPEED SENSOR SIGNAL
HINT.

(See TEST MODE PROCEDURE )