Charging System: Generator: Installation

INSTALL GENERATOR
1. Using an E8 "TORX" socket wrench, set the generator with the 2 stud bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 1: Locating Generator Stud Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the generator with the 2 bolts and 2 nuts.
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Fig 2: Locating Generator Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the wire harness bracket with the nut
  Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf)
  
  Fig 3: Locating Wire Harness Bracket Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the harness to the +B terminal with nut A.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
5. Install the oil cooler tube with bolt B.
  Torque: 14 N*m (140 kgf*cm, 10 ft.*lbf)
6. Connect wire harness clamp C.
7. Connect generator connector D.
INSTALL FRONT STABILIZER BAR
1. Install the front stabilizer bar (See INSTALLATION ).
  
  Fig 4: Locating Oil Cooler Tube Bolt And Generator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WIRE HARNESS
1. Connect the wire harness with the bolt and clamp
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 5: Locating Ground Cable Clamp And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V-RIBBED BELT (See INSTALLATION )
INSTALL RADIATOR RESERVE TANK ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
INSTALL REAR ENGINE UNDER COVER LH
INSTALL REAR ENGINE UNDER COVER RH
INSTALL ENGINE UNDER COVER
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL FRONT WHEELS
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).