Charging System: Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE COOL AIR INTAKE DUCT SEAL (See REMOVAL )
REMOVE ENGINE ROOM SIDE COVER RH (See REMOVAL )
REMOVE FRONT WHEELS
REMOVE ENGINE UNDER COVER
REMOVE REAR ENGINE UNDER COVER LH
REMOVE REAR ENGINE UNDER COVER RH
REMOVE NO. 1 AIR CLEANER INLET (See REMOVAL )
REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See REMOVAL )
REMOVE AIR CLEANER CASE SUB-ASSEMBLY (See REMOVAL )
SEPARATE RADIATOR RESERVE TANK ASSEMBLY (See REMOVAL )
REMOVE V-RIBBED BELT (See REMOVAL )
DISCONNECT WIRE HARNESS
1. Remove the bolt, and disconnect the clamp and ground cable.
  
  Fig 1: Locating Ground Cable Clamp And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT STABILIZER BAR
1. Remove the front stabilizer bar (See REMOVAL ).
REMOVE GENERATOR
1. Remove nut A, and disconnect the harness from the +B terminal
2. Remove bolt B, and disconnect the oil cooler tube.
3. Remove clamp C
4. Disconnect generator connector D.
5. Remove the nut and wire harness bracket
  
  Fig 3: Locating Wire Harness Bracket Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 2 bolts and 2 nuts
  
  Fig 4: Locating Generator Bolts And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator
  
  Fig 5: Locating Generator Stud Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002