Engine Oil Temperature Sensor: Installation

INSTALL OIL TEMPERATURE SENSOR
1. Using SST, install the temperature sensor with a new gasket
  SST 09922-10010
  
  Torque: without SST
  
  39 N*m (400 kgf*cm, 29 ft.*lbf)
  
  Torque: with SST
  
  30 N*m (301 kgf*cm, 22 ft.*lbf)
  NOTE:
  - The "with SST" torque value is effective when using SST with a fulcrum length of 96 mm (3.78 in.).
  - The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (See REPAIR INSTRUCTION ).
  - The "with SST" torque value is effective when SST is parallel to the torque wrench.
    
    Fig 1: Installing Temperature Sensor With Gasket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not subject the temperature sensor to any impacts.
  - If the sensor is subjected to an impact, replace the temperature sensor with a new one.
  - Do not allow any moisture or foreign matter to enter the temperature sensor or its connector.
2. Connect the temperature sensor connector.
INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
1. Install the engine oil pressure switch (See INSTALLATION ).
INSPECT FOR OIL LEAK