LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS F >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel >> Fuel Sender Gauge Assembly >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Sender Gauge Assembly: Removal

  1. DISCHARGE FUEL SYSTEM PRESSURE 
    1. Discharge fuel system pressure (See FUEL SYSTEM )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  3. REMOVE REAR SEAT CUSHION ASSEMBLY  (See REMOVAL )
  4. REMOVE NO. 3 ROOM PARTITION PAD  (See REMOVAL )
  5. REMOVE REAR FLOOR SERVICE HOLE COVER  (See REMOVAL )
  6. REMOVE NO. 2 REAR FLOOR SERVICE HOLE COVER  (See REMOVAL )
  7. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY  (See REMOVAL )
  8. REMOVE FUEL SENDER GAUGE  (See REMOVAL )
  9. REMOVE FUEL SENDER GAUGE ASSEMBLY 
    1. Disconnect the fuel sender gauge assembly connector from the fuel suction plate.
    2. Press down on the fuel sender gauge assembly claw labeled A. Then slide the fuel sender gauge assembly upward
      NOTE: Do not touch the sender resistance plate or contact area.
      Fig 1: Locating Fuel Sender Gauge Assembly
      G05750059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals