Injector Driver: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE INJECTOR DRIVER
1. Disconnect the 8 injector driver connectors
  1. Disconnect the 6 connectors with wire harness locks and the 2 connectors without wire harness locks from the 2 injector drivers.
    HINT.
    
    To release each connector lock, push the claw downward ("Release" in the illustration) and move the lock lever ("Move" in the illustration).
    
    Fig 1: Locating Injector Driver Connectors
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 8 nuts and 2 injector drivers from the intake air surge tank assembly
  NOTE: Be careful not to drop or strike the injector drivers.
  
  Fig 2: Locating Injector Drivers Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002