LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> IS F >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle >> Transmission Control Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Control Switch: Installation

  1. INSTALL TRANSMISSION CONTROL SWITCH 
    1. Apply MP grease to the hatched area of the shift lever guide housing as indicated in the illustration.
      Fig 1: Identifying MP Grease Applying Area
      G05318256Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the transmission control switch to the shift lever guide housing.
      NOTE: Securely engage the claws.
      Fig 2: Locating Transmission Control Switch From Shift Lever Guide Housing
      G05318249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install the shift lever guide housing with the shift lever lock pin and a new shift lever support
      NOTE:
      • Install the shift lever nut and lock pin after first engaging the 2 claws.
      • Securely engage the claws.
        Fig 3: Locating Shift Lever Guide Housing
        G05318248Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Connect the transmission control switch connector to the floor shift assembly.
    Fig 4: Locating Transmission Control Switch Connector
    G05318247Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY  (See REASSEMBLY  )
  3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY  (See INSTALLATION  )
  4. ADJUST SHIFT LEVER POSITION  (See ADJUSTMENT  )
  5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR  (See INSTALLATION )
  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY  (See INSTALLATION )
  7. CONNECT HEATED OXYGEN SENSOR  (See INSTALLATION )
  8. INSTALL FRONT CENTER FLOOR BRACE  (See INSTALLATION )
  9. INSTALL REAR NO. 1 FLOOR PANEL BRACE  (See INSTALLATION )
  10. INSTALL NO. 2 FLOOR UNDER COVER  (See INSTALLATION )
  11. INSTALL NO. 1 FLOOR UNDER COVER  (See INSTALLATION )
  12. INSTALL NO. 2 CONSOLE BOX DUCT  (See INSTALLATION )
  13. INSTALL CONSOLE BOX  (See INSTALLATION )
  14. INSTALL CONSOLE BOX REGISTER ASSEMBLY  (See INSTALLATION )
  15. INSTALL REAR ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  16. INSTALL FRONT ASH RECEPTACLE ASSEMBLY  (See INSTALLATION )
  17. INSTALL CONSOLE PANEL SUB-ASSEMBLY  (See INSTALLATION )
  18. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH  (See INSTALLATION )
  19. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH  (See INSTALLATION )
  20. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
  21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  22. INSPECT SHIFT LEVER POSITION  (See ON-VEHICLE INSPECTION  )
  23. INSPECT FOR EXHAUST GAS LEAK 
scientia non olet · About LEMON Manuals