Transmission Wire: Installation

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring with ATF and install it to the transmission wire connector.
2. Install the transmission wire
3. Using a 10 mm union nut wrench, install the bolt.
  Torque: without a union nut wrench
  
  5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  with a union nut wrench
  
  4.8 N*m (49 kgf*cm, 42 in.*lbf)
  
  NOTE: Use a torque wrench with a fulcrum length of 185 mm (7.28 in.).
  
  Fig 1: Pulling Out Transmission Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the wire connector
  HINT
  
  Push up the lever until the claw of the transmission wire connector makes a connection sound
  
  Fig 2: Pushing Up Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the 3 speed sensor connectors
INSTALL TRANSMISSION VALVE BODY ASSEMBLY (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY (See INSTALLATION )
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid (See AUTOMATIC TRANSMISSION FLUID ).
INSTALL NO. 2 ENGINE UNDER COVER