How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the power window control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK FOR DTC (ELECTRIC POWER CONTROL SYSTEM)* 
   1. Using the Techstream, check if the electric power control system is functioning normally.

      Result: 

      RESULT TABLE
      
      

      Result	Proceed to
      DTC B22B3 is not output	A
      DTC B22B3 is output	B

   B: GO TO ELECTRIC POWER CONTROL SYSTEM  (See DIAGNOSTIC TROUBLE CODE TABLE )

   A: Go to next step 

4. CHECK FOR DTC* 
   1. Check for DTCs and note any codes that are output.
   2. Delete the DTC.
   3. Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the symptoms indicated by the DTC.

      Result: 

      RESULT TABLE
      
      

      Result	Proceed to
      No DTCs output	A
      DTC B2311 is output	B
      DTC B2312 is output	B
      DTC B2313 is output	B
      CAN communication system DTC is output	C
      LIN communication system DTC is output	D

   B: GO TO  DIAGNOSTIC TROUBLE CODE TABLE  

   C: GO TO CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

   D: GO TO LIN COMMUNICATION SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

   A: Go to next step 

5. PROBLEM SYMPTOMS TABLE 

   Result: 

   RESULT TABLE
   
   

   Result	Proceed to
   Fault not listed in problem symptoms table	A
   Fault listed in problem symptoms table	B

   B: GO TO STEP   7 

   A: Go to next step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. See OPERATION CHECK 
   2. See TERMINALS OF ECU 
   3. See DATA LIST/ACTIVE TEST 
7. REPAIR OR REPLACE 

   Result: 

   RESULT TABLE
   
   

   Result	Proceed to
   Door window regulator and power window regulator motor assembly is replaced or removed/installed.	A
   Door window regulator and power window regulator motor assembly is not replaced or removed/installed.	B

   B: GO TO STEP   9 

   A: Go to next step 

8. RESET POWER WINDOW MOTOR 
   1. If the power window master switch AUTO light is blinking, reset the power window motor (see INITIALIZATION  ).
9. CONFIRMATION TEST 

   NEXT: END