How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the push-button start function.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Using the Techstream, check if the CAN communication system is functioning normally (see DIAGNOSIS SYSTEM ).

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

   B: GO TO DIAGNOSTIC TROUBLE CODE CHART 

   A: Go to Next Step 

4. CHECK FOR DTC* 
   1. Check for DTCs and note any stored DTCs (see DTC CHECK / CLEAR  ).
   2. Delete the DTCs.
   3. Check whether the same DTC(s) relevant to the SFI system or smart access system with push-button start recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC output does not reoccur	A
      SFI system DTC output reoccurs	B
      Smart access system with push-button start DTC output reoccurs	C

   B:  GO TO SFI SYSTEM

   C: GO TO STEP  7

   A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: GO TO STEP  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Terminals of ECU (see TERMINALS OF ECU  )
   2. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST  )
7. ADJUST, REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END