Fuel Pump: Reassembly

INSTALL BRACKET
1. Install the bracket to the fuel filter.
  
  Fig 1: Identifying Fuel Filter Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL PUMP ASSEMBLY
1. Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
  
  Fig 2: Identifying O-Ring And Spacer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve and fuel pressure regulator.
  
  Fig 3: Identifying O-Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the fuel main valve and fuel pressure regulator to the fuel filter.
4. Attach the 2 claws of the fuel filter and install the cap.
  NOTE:
  - Make sure that the fuel main valve and fuel pressure regulator is not installed backwards. If installed backwards, the engine may stall.
  - Make sure the O-rings are not cut or pinched during the installation.
  - Attach the claws securely.
5. Engage the 5 claws on the fuel filter and install the fuel pump with pump filter.
  NOTE:
  - Make sure the O-rings are not cut or pinched during the installation.
  - Attach the claws securely.
    
    Fig 5: Locating Fuel Pump With Pump Filter
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Connect the fuel pump connector to the fuel pump.
  
  Fig 6: Locating Fuel Pump Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL JET PUMP
1. Apply gasoline to a new O-ring and install it to the jet pump.
  
  Fig 7: Removing O-Ring From Jet Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the jet pump to the sub-tank as shown in the illustration.
  
  Fig 8: Installing Jet Pump To Sub-Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL FILTER
1. Install the fuel filter to the sub-tank and attach the 2 claws.
INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY
1. Install the spring to the fuel suction plate shaft.
2. Install the fuel suction plate to the sub-tank.
3. Install a new E-ring.
  
  Fig 10: Identifying E-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the fuel pump connector to the fuel suction plate.
  
  Fig 11: Locating Fuel Pump Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Set the fuel sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.
2. Connect the fuel sender gauge connector to the fuel suction plate.
  NOTE: Do not touch the sender plate's resistance plate area or the contact area.
  
  Fig 12: Connecting Fuel Sender Gauge Connector To Fuel Suction Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002