Multiplex Tilt And Telescopic Ecu: Installation

1. Install the ECU with the 2 screws.

   Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) 

2. Connect the ECU connector.
   NOTE: The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape. When installing them, connect the connectors of the same color.
   Fig 1: Identifying Multiplex Tilt And Telescopic ECU Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.
   Fig 2: Installing Steering Lock Actuator Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the 2 tapered-head bolts until the bolt heads break off.

HINT:

Refer to the instructions for installation of the steering column assembly (see INSTALLATION  ).