Tilt And Telescopic Manual Switch: Installation

INSTALL TILT AND TELESCOPIC MANUAL SWITCH
1. Attach the claw to install the tilt and telescopic manual switch.
2. Connect the connector.
  
  Fig 1: Identifying Tilt And Telescopic Switch Connector With Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER
1. Attach the clip to install the steering column cover upper.
2. Attach the 4 clips to install the steering column cover upper onto the instrument panel cluster finish panel.
  
  Fig 2: Attaching Clip To Steering Column Cover Upper
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the steering column lower cover and attach the 2 claws.
4. Install the screw.
  Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf)
  
  Fig 3: Identifying Steering Column Lower Cover With Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the 2 screws.
  Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf)
  
  HINT:
  
  Turn the steering wheel to the right and left as necessary to install the 2 screws.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter (see CUSTOMIZE PARAMETERS ).

Fig 4: Turning Steering Wheel To Right And Left
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COWL TOP VENTILATOR LOUVER RH (See INSTALLATION )
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (see DIAGNOSIS SYSTEM ).
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal.