Skid Control Buzzer: Installation

NOTE: While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/ close the doors while the battery is connected.

INSTALL SKID CONTROL BUZZER ASSEMBLY
NOTE: If the buzzer connector is connected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to install the buzzer according to the procedures below.
1. Connect the connector.
2. Attach the clamp and install the buzzer to the extension panel.
Fig 1: Identifying Buzzer From Extension Panel And Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY (See INSTALLATION ).
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (See INSTALLATION ).
INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (See INSTALLATION ).
INSTALL STEERING COLUMN COVER (w/o Driver Monitor Camera) (See INSTALLATION ).
INSTALL STEERING COLUMN COVER (w/ Driver Monitor Camera) (See INSTALLATION ).
INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING (See INSTALLATION ).
INSTALL INSTRUMENT SIDE PANEL LH (See INSTALLATION ).
INSTALL INSTRUMENT PANEL FINISH PANEL END LH (See INSTALLATION ).
INSTALL SERVICE PLUG GRIP (See INSTALLATION ).
INSTALL BATTERY SERVICE HOLE COVER (See INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter (see CUSTOMIZE PARAMETERS ).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION ).
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION ).