LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> LX 570 >> Repair and Diagnosis >> Body & Frame >> Windows >> Windshield/WINDOWGLASS >> Power Window Control System >> Operation Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operation Check

  1. CHECK WINDOW LOCK SWITCH 

    HINT:

    Before performing the window lock switch operation check, make sure that the window lock switch is off (the switch is not pushed in).

    1. Check that the front passenger side power window and the rear power windows cannot be operated when the window lock switch of the multiplex network master switch is pressed.
      Fig 1: Identifying Window Lock Switch
      G04952071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: Operation of front passenger side power window and rear power windows are disabled. 

    2. Check that the front passenger side power window and the rear power windows can be operated when the window lock switch is pressed again.

      OK: Front passenger side power window and rear power windows can be operated. 

  2. CHECK MANUAL UP/DOWN FUNCTION 
    1. Check that the driver side power window operates as follows:

      OK 

      CONDITION CHART

      Condition Multiplex Network Master Switch Switch Operation Power Window
      Engine switch on (IG) Driver side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
    2. Check that the front passenger side and rear power windows operate as follows:

      OK 

      CONDITION CHART

      Condition Power Window Regulator Switch Switch Operation Power Window
      • Engine switch on (IG)
      • Window lock switch off
      		 Front passenger side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
      Rear LH side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
      Rear RH side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
  3. CHECK AUTO UP/DOWN FUNCTION 
    1. Check that the driver side power window operates as follows:

      OK 

      CONDITION CHART

      Condition Multiplex Network Master Switch Switch Operation Power Window
      Engine switch on (IG) Driver side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
    2. Check that the front passenger side and rear power windows operate as follows:

      OK 

      CONDITION CHART

      Condition Power Window Regulator Switch Switch Operation Power Window
      • Engine switch on (IG)
      • Window lock switch off
      		 Front passenger side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
      Rear LH side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
      Rear RH side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
  4. CHECK REMOTE MANUAL UP/DOWN FUNCTION 
    1. Check that the front passenger side and rear power windows operate as follows:

      OK 

      CONDITION CHART

      Condition Multiplex Network Master Switch Switch Operation Power Window
      • Engine switch on (IG)
      • Window lock switch off
      		 Front passenger side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
      Rear LH side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
      Rear RH side Pulled halfway up Up (Closes)
      Pushed halfway down Down (Opens)
  5. CHECK REMOTE AUTO UP/DOWN FUNCTION 
    1. Check that the front passenger side and rear power windows operate as follows:

      OK 

      CONDITION CHART

      Condition Multiplex Network Master Switch Switch Operation Power Window
      • Engine switch on (IG)
      • Window lock switch off
      		 Front passenger side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
      Rear LH side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
      Rear RH side Pulled up (One touch operation) Auto up (Closes)
      Pushed down (One touch operation) Auto down (Opens)
  6. CHECK POWER WINDOW OPERATION FUNCTION AFTER ENGINE SWITCH OFF 
    1. Check that all the power windows can be operated with the multiplex network master switch after the engine switch is turned off.
    2. Check that the key-off operation function does not operate after a front side door is opened.
    3. Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the engine switch was turned off.
  7. CHECK TRANSMITTER-LINKED FUNCTION 
    1. Check that all power windows operate as follows when operating the transmitter.

      OK 

      CONDITION CHART

      Condition Transmitter Operation Power Window
      No key is inside vehicle, and all doors are closed and locked Unlock switch pressed for more than 3 0 sec Down (Opens)
      No key is inside vehicle, and all doors are closed and locked Unlock switch released Stop
  8. CHECK KEY-LINKED FUNCTION USING DRIVER SIDE DOOR KEY CYLINDER 
    1. Check that all power windows operate as follows.

      OK 

      CONDITION CHART

      Condition Door Key Cylinder Operation Power Window
      No key is inside vehicle, and all doors are closed Turned to lock for more than 2 3 sec Up (Closes)
      No key is inside vehicle, and all doors are closed. Returned to neutral position Stop
      No key is inside vehicle, and all doors are closed. Turned to unlock for more than 2 3 sec Down (Opens)
      No key is inside vehicle, and all doors are closed Returned to neutral position Stop
  9. CHECK ENTRY LOCK SWITCH-LINKED CLOSE FUNCTION 
    1. Check that all power windows operate as follows when the entry lock switch is pressed and held.

      OK 

      CONDITION CHART

      Condition Switch Operation Power Window
      No key is inside vehicle, and all doors are closed. Entry lock switch pressed for more than 3 0 sec Up (Closes)
      No key is inside vehicle, and all doors are closed Entry lock switch released. Stop
  10. CHECK JAM PROTECTION FUNCTION 
    1. Check the basic function.
      CAUTION:
      • The jam protection function is operative during both the auto up and manual up operation.
      • Do not put your fingers between the door frame and door glass to check functions. Also, prevent any part of your body from being caught during inspection.

      HINT:

      The jam protection function is operative during both the auto up and manual up operation while the engine is running or the engine switch is on (IG), and also 45 seconds after the engine switch is turned off.

      1. Fully open the window.
      2. Hold a thick book wrapped with cloth in the position shown in the illustration.
      3. Operate the auto up or manual up function to check that the power window goes down when the window contacts the book, and stops when the opening reaches approximately 200 mm (7.87 in.).

        HINT:

        The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds have elapsed.

      4. While the power window is moving down, check that the door glass cannot be moved up even when the power window regulator switch is used.
        Fig 2: Checking Jam Protection Function
        G04952072Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. CHECK POWER WINDOW REGULATOR SWITCH LED ILLUMINATION 
    1. Inspect the power window switch LED illumination for each seat when turning the window lock switch on/off.
      1. Driver Seat:
        1. When the window lock switch is on, check that all LEDs of the multiplex network master switch turn off except for the LED of the switch corresponding to the driver seat.
        2. When the window lock switch is off, check that all LEDs of the multiplex network master switch turn on.
      2. Front passenger, rear left and rear right seats:
        1. When the window lock switch is on, check that the power window regulator switch LED of each seat turns off.
        2. When the window lock switch is off, check that the power window regulator switch LED of each seat turns on
scientia non olet · About LEMON Manuals