Rear Speed Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.NOTE:
- w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
- w/ Navigation System:
- REMOVE REAR WHEEL
- REMOVE SKID CONTROL SENSOR WIRE
- Disconnect the speed sensor LH connector.
- Detach the 2 clamps and remove the bolt and sensor clamp.
- Detach the 5 clamps.
- Detach the 3 clamps.
- Disconnect the speed sensor RH connector.
- Remove the bolt.
- Disconnect the connector, and remove the bolt and skid control sensor wire.
- REMOVE REAR SPEED SENSOR LH
- Remove the nut and speed sensor.
NOTE: Pull out the sensor while trying as much as possible not to rotate it. - REMOVE REAR SPEED SENSOR RH
- Remove the nut and speed sensor.
NOTE: Pull out the sensor while trying as much as possible not to rotate it.