Steering Angle Sensor: Installation
- INSTALL STEERING ANGLE SENSOR
- Align the installation holes on the steering angle sensor with the pins on the spiral cable.
- Attach the 6 claws to install the steering angle sensor to the spiral cable.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- INSTALL SPIRAL CABLE SUB-ASSEMBLY
(See
INSTALLATION
)
- INSTALL UPPER STEERING COLUMN COVER
(See
INSTALLATION
)
- INSTALL LOWER STEERING COLUMN COVER
(See
INSTALLATION
)
- ADJUST SPIRAL CABLE
(See
INSTALLATION
)
- INSTALL STEERING WHEEL ASSEMBLY
(See
INSTALLATION
)
- INSTALL STEERING PAD
(See
INSTALLATION
)
- INSTALL LOWER NO. 2 STEERING WHEEL COVER
(See
INSTALLATION
)
- INSTALL LOWER NO. 3 STEERING WHEEL COVER
(See
INSTALLATION
)
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See
CUSTOMIZE PARAMETERS
).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See
INITIALIZATION
).
- CHECK SRS WARNING LIGHT
- Check the SRS warning light (See
DIAGNOSIS SYSTEM
).