Park/ Neutral Position Switch: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Remove the clip and pin, and disconnect the shifting rod from the transmission control shaft lever RH.
REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Disconnect the switch connector.
2. Remove the nut, spring washer and transmission control shaft lever RH.
3. Remove the collar and transmission control rod bush from the transmission control shaft lever RH.
  
  Fig 2: Locating Spring Washer And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a screwdriver, bend the tabs of the lock washer.
  
  Fig 3: Bending Tabs Of Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the lock nut and lock washer.
  
  Fig 4: Locating Lock Nut And Lock Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the bolt and switch.
Fig 5: Locating Bolt And Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002