Steering Angle Sensor: Installation

INSTALL STEERING ANGLE SENSOR
1. Install the steering angle sensor to the spiral cable.
  NOTE:
  - Install the claw securely.
  - Do not damage the claw.
ADJUST CENTER FRONT WHEEL
INSTALL SPIRAL CABLE (See INSTALLATION )
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Manual Tilt) (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (for Power Tilt and Power Telescopic) (See INSTALLATION )
INSTALL STEERING PAD (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
INSPECT STEERING PAD (See DISPOSAL )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT
HINT:

See DIAGNOSIS SYSTEM
INSPECT ABS WARNING LIGHT AND VSC WARNING LIGHT
HINT:

See TEST MODE PROCEDURE