How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the power window control system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 
3. INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)* 
   1. Use the Techstream to check if the Multiplex Communication System (MPX) is functioning normally.

      Result 

      RESULT REFERENCE CHART
      
      

      Result	Proceed to
      MPX DTC is not output	A
      MPX DTC is output	B

   B:  GO to MULTIPLEX COMMUNICATION SYSTEM

   A: Go to Next Step 

4. CHECK FOR DTC* 
   1. Check for DTC and note any codes that are output.
   2. Delete the DTC.
   3. Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Result 

      RESULT REFERENCE CHART
      
      

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

   B: Go to DIAGNOSTIC TROUBLE CODE CHART 

   A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to Step  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. See DATA LIST / ACTIVE TEST  .
   2. See ON-VEHICLE INSPECTION  .
   3. See TERMINALS OF ECU  .
   4. Inspection.
      1. Inspect master switch (see INSPECTION  ).
      2. Inspect power window switch (see INSPECTION  ).
      3. Inspect power window motor (see INSPECTION  ).
7. ADJUST, REPAIR OR REPLACE 
8. CONFIRMATION TEST 

   NEXT: END