Rear Speed Sensor: Installation

INSTALL REAR SPEED SENSOR RH
1. Install the sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
2. Install the No. 2 clamp with the nut.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. Connect the sensor connector.
  
  Fig 1: Identifying Bolt And Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SPEED SENSOR LH
1. Install the sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 2: Identifying Bolt And Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the No. 1 clamp with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. Install the No. 2 and No. 3 clamps with the bolt and 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
4. Connect the HID connector, and then install the resin clamp and clamp bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
5. Connect the sensor and HID connector.
INSTALL REAR SEATBACK ASSEMBLY (See INSTALLATION )
INSTALL REAR SEAT HEADREST ASSEMBLY (See INSTALLATION )
INSTALL REAR SEAT HEADREST PLATE (See INSTALLATION )
INSTALL WIND DEFLECTOR BOARD ASSEMBLY (See INSTALLATION )
INSTALL REAR SEAT HEADREST PLATE COVER (See INSTALLATION )
INSTALL REAR SEAT CUSHION ASSEMBLY (See INSTALLATION )
INSTALL REAR WHEEL
1. Install the wheel with the 5 nuts.
  Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
2. Install the ornament with the 10 bolts.
  Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf)
CHECK ABS SPEED SENSOR SIGNAL
1. Check the speed sensor signal (see TEST MODE PROCEDURE ).