Inspection Procedure
- PERFORM ACTIVE TEST BY TECHSTREAM (SLIP INDICATOR LIGHT)
- Using the Techstream Active Test, generate a control command and then check that the SLIP indicator light operates.
ABS/VSC/TRAC
DIAGNOSTIC NOTE CHARTTester Display Test Part Control Range Diagnostic Note Slip Indicator Light Turns SLIP indicator light ON/OFF Observe combination meter - OK: SLIP indicator light is turned on or off in accordance with Techstream.
OK: REPLACE SKID CONTROL ECU
NG: Go to Next Step
- Using the Techstream Active Test, generate a control command and then check that the SLIP indicator light operates.
- CHECK MULTIPLEX COMMUNICATION SYSTEM (SKID CONTROL ECU - COMBINATION METER)
- Check for open and short circuits in the multiplex communication system between the skid control ECU and combination meter.
NG: REPAIR OR REPLACE MULTIPLEX COMMUNICATION SYSTEM
OK: Go to Next Step
- CHECK COMBINATION METER (SLIP INDICATOR LIGHT)
- Check the combination meter (see PROBLEM SYMPTOMS TABLE ).
NG: REPAIR OR REPLACE COMBINATION METER
OK: REPLACE SKID CONTROL ECU