Charging Systems: Charging: Generator: Installation

INSTALL GENERATOR ASSEMBLY
1. Install the generator with the 2 nuts and bolt.
  Torque:
  
  39 N*m (398 kgf*cm, 29 ft.*lbf) for bolt and nut A
  
  15 N*m (153 kgf*cm, 11 ft.*lbf) for nut B
2. Connect the engine wire bracket with the bolt.
  
  Fig 1: Identifying Engine Wire Bracket With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VANE PUMP PULLEY
1. Using SST, install the vane pump pulley with the nut.
  SST 09960-10010
  
  Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
  
  Fig 2: Identifying Vane Pump Pulley With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL ENGINE UNDER COVER
INSTALL V-BANK COVER (See INSTALLATION )
INSTALL NO. 1 AIR CLEANER INLET (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.