Charging Systems: Charging: Generator: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE NO. 1 AIR CLEANER INLET (See REMOVAL )
REMOVE V-BANK COVER (See REMOVAL )
REMOVE ENGINE UNDER COVER
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
REMOVE VANE PUMP PULLEY
1. Using SST, remove the nut and vane pump pulley.
  SST 09960-10010
  
  Fig 1: Identifying Vane Pump Pulley
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE GENERATOR ASSEMBLY
1. Disconnect the generator connector.
2. Remove the rubber cap and nut, and disconnect the generator wire.
3. Remove the bolt and disconnect the engine wire bracket.
4. Remove the 2 nuts, bolt and generator.
  NOTE: If the stud bolt of the nut is loose, replace the stud bolt.
  
  Fig 2: Identifying Generator Nuts And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002