DTC Check / Clear

NOTE: When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are erased. Before changing modes, always check and make a note of DTCs and freeze frame data.

HINT:

DTCs stored in the ECM can be displayed on the Techstream. The Techstream can display current and pending DTCs.
The same DTCs are not set if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.

CHECK DTC (Using the Techstream)
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester ON.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Check the DTC(s) and freeze frame data, and then write them down.
6. Check the details of the DTC(s) (see DIAGNOSTIC TROUBLE CODE CHART ).
CLEAR DTC (Using the Techstream)
1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester ON.
4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
5. Press the YES button.
CLEAR DTC (Without using the Techstream)
1. Perform either one of the following operations.
  1. Disconnect the negative (-) battery cable for more than 1 minute.
  2. Remove the EFI and ETCS fuses from the engine room No. 2 relay block located inside the engine compartment for more than 1 minute.