Throttle Body: Installation

INSTALL THROTTLE BODY
1. Install a new gasket and the throttle body with the 2 bolts and 2 nuts.
  Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
2. Connect the 2 water by-pass hoses.
3. Connect the ventilation hose.
4. Connect the connector.
Fig 1: Locating Bolts, Nuts And Throttle Body
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR CONNECTOR PIPE
1. Install the connector pipe with the bolt and 2 hose clamps.
  Torque: 4.0 N*m (41 kgf*cm, 35 ft.*lbf) for hose clamps
  
  5.0 N*m (51 kgf*cm, 44 ft.*lbf) for bolt
2. Connect the air hose and No. 1 ventilation hose.
INSTALL NO. 1 AIR CLEANER INLET
1. Install the air cleaner inlet with the bolt.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)

Fig 2: Locating Connector Pipe With Bolt And Hose Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL V - BANK COVER
1. Install the cover with the 2 clips.
2. Install the 2 nuts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 3: Locating Bolt And Air Cleaner Inlet
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
ADD ENGINE COOLANT (See COOLANT )
CHECK FOR ENGINE COOLANT LEAKS (See ON-VEHICLE INSPECTION )