DTC Check/Clear

DTC CHECK/CLEAR (WHEN USING TECHSTREAM)
1. DTC check
  1. Connect the Techstream to the DLC3.
  2. Turn the engine switch on (IG).
  3. Read the DTCs following the prompts on the tester screen.
2. DTC clear
  1. Connect the Techstream to the DLC3.
  2. Turn the engine switch on (IG).
  3. Operate the Techstream to clear the codes.
    HINT:
    
    Refer to the Techstream operator's manual for further details.

DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)

DTC check

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
SST 09843-18040
Turn the engine switch on (IG).

Read DTC from the ABS warning light on the combination meter and multi-information display.

Fig 1: Identifying DLC3 Connector Terminals TC And CG

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

If no code appears, inspect the TC and CG terminal circuit, ABS warning light and brake warning light/yellow (minor malfunction) circuits and brake hold standby indicator light circuit.

TROUBLE AREA REFERENCE CHART

Trouble Area	See procedure
TC and CG terminal circuit	TC AND CG TERMINAL CIRCUIT
ABS warning light circuit (light remains on)	ABS WARNING LIGHT REMAINS ON
ABS warning light circuit (light does not come on)	ABS WARNING LIGHT DOES NOT COME ON
Brake warning light/yellow (minor malfunction) circuit (light remains on)	BRAKE CONTROL WARNING LIGHT REMAINS ON
Brake warning light/yellow (minor malfunction) circuit (light does not come on)	BRAKE CONTROL WARNING LIGHT DOES NOT COME ON
Brake hold standby indicator light circuit	BRAKE HOLD STANDBY INDICATOR LIGHT CIRCUIT

As an example, the illustration below shows the blinking patterns of the normal system code and trouble codes 31 and 43, and display of the normal system code and trouble code 31 on the multi-information display.

Fig 2: ABS Warning Light Blinking Pattern
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
The codes are explained in the code table (see DIAGNOSTIC TROUBLE CODE CHART ).
After completing the check, disconnect terminals TC and CG of the DLC3, and turn the display off. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

DTC clear
1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
  SST 09843-18040
2. Turn the engine switch on (IG).
  
  Fig 3: Identifying DLC3 Connector Terminals TC And CG
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
4. Check that the warning light and multi-information display indicate the normal system code.
5. Remove SST from the terminals of the DLC3.
  HINT:
  
  Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG fuse.
  
  Fig 4: Depressing Brake Pedal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

END OF DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE)
1. Turn the engine switch on (IG).
2. Check that the ABS warning light, brake warning light/yellow (minor malfunction) and brake hold standby indicator light illuminate. After the engine is started, check that they turn off.