Engine Switch: Inspection

INSPECT ENGINE SWITCH

Measure the resistance according to the value(s) in the table below.

Fig 1: Identifying Claws And Switch

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance

RESISTANCE REFERENCE

Fig 2: Identifying Engine Switch Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the engine switch.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

HINT:

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

If the voltage is too low, the indicator will not illuminate.

ITEM SPECIFICATION

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 11 (SWIL) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates
Battery positive (+) → Terminal 12 (INDS) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates
Battery positive (+) → Terminal 13 (INDW) Battery negative (-) → Terminal 4 (COM) or 5 (GND)	Illuminates

Fig 3: Identifying Engine Switch Connector Terminal

If the result is not as specified, replace the engine switch.