Fuel Pressure Sensor: Installation

INSTALL FUEL PRESSURE SENSOR
1. Install a new gasket to the fuel pressure sensor.
2. Using SST, install the fuel pressure sensor to the fuel delivery pipe.
  SST 09922-10010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  30 N*m (306 kgf*cm, 22 ft.*lbf)
  NOTE:
  - Do not apply oil to threads of the pressure sensor and delivery pipe.
  - Do not allow foreign matter to enter the pipe during the installation.
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).
  - Make sure SST and torque wrench are connected in a straight line.
    
    Fig 1: Installing Fuel Pressure Sensor To Fuel Delivery Pipe
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector.
  
  Fig 2: Locating Fuel Pressure Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY

Fig 3: Identifying No. 2 Engine Cover
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE MANIFOLD
1. Install the intake manifold (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR COOLANT LEAK (See ON-VEHICLE INSPECTION )
INSPECT FOR FUEL LEAK (See ON-VEHICLE INSPECTION )