Advanced Parking Guidance System (Initialization)

HINT: 

• If the following operations are performed "SYSTEM INITIALIZING" is displayed on the multi-display. Also, when the expected course lines not displayed the parking guidelines are displayed, pressing the parking assist mode switch and parallel parking assist mode switch causes the message "! System cannot guide under current conditions." to be displayed.

  Part Name	Operation	Initialization Item
  Battery cable	Disconnect	Steering angle neutral point
  Steering angle sensor connector	Disconnect	Steering angle neutral point

• Move the vehicle to a level area.
• Perform either of the following initialization procedures.

1. Initialization with diagnosis system
   1. Start the diagnostic system.
   2. Perform STEERING CENTER MEMORIZE and MAX STEERING ANGLE MEMORIZE on the STEERING ANGLE SETTING screen.
   3. Finish the diagnostic system.
2. Initialization with manual operation
   1. Turn the power switch ON (IG) or start the hybrid control system.
   2. Fully turn the steering wheel to the right.*
   3. Fully turn the steering wheel to the left.*

      HINT: 

      *: These procedures can be performed as shown or in reverse.