Hybrid Transmission System

HINT: 

Disconnecting the negative battery terminal does not initialize (clear) the learned value.

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (READY) and turn the Techstream on.
3. Select the following menu items:
   NOTE:

   Check that the shift lever is in the P position and turn the power switch on (READY).

   1. Techstream - Select : Powertrain / Hybrid Control / Data List. Read the data list before performing Reset Memory.
      CHECK ITEM (TECHSTREAM)
      
      

      Item	Specified Condition
      +B	9 to 16 V
      WOUT Control Power	1000 W or more
      T/M Oil Temperature	10 to 100 °C (50 to 212 °F)

      NOTE:

      • Do not depress the accelerator pedal during Reset Memory.
      • Do not move the shift lever from the P position.
      • If the specified conditions above are not satisfied, warm up the hybrid system with the power switch on (READY) until each item meets the specified condition.
4. Select the following menu items:
   1. Techstream - Select: Powertrain / Hybrid Control / Reset Memory.
      WARNING:

      After performing Reset Memory, be sure to perform a road test described earlier.

      NOTE:

      During Reset Memory, do not turn off either the power switch or the Techstream.

      HINT: 

      • Approximately 1 minute is required to complete Reset Memory.
      • The ECU is learned by performing a road test.