LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2009 >> LS 600hL >> Repair and Diagnosis >> General Information >> Identification >> Introduction >> Repair Instruction >> Initialization >> Reset Power Trunk Lid System
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reset Power Trunk Lid System

  1. RESET METHOD
    NOTE:

    Perform initialization of the power trunk lid system (power trunk lid control ECU initialization) if one of the following is performed: 1) The negative (-) battery cable is disconnected; 2) a wire harness, the luggage closer motor (power trunk lid control ECU) or luggage compartment door closer is replaced or removed/installed; or 3) the RR MPX-B1 fuse is replaced or removed/installed. If initialization is not performed, the power trunk lid system will not operate.

  2. Completely close the luggage compartment door by hand once.

    HINT: 

    It is not necessary to perform initialization if the negative (-) battery cable is disconnected while the luggage compartment door is closed.

  3. CHECK POWER TRUNK LID FUNCTION

    HINT: 

    • Proceed to Operation Check.
    • If the power trunk lid system does not operate and/or the luggage compartment door does not open, disconnect the negative (-) battery cable. Then wait 10 seconds, reconnect the cable and perform initialization of the power trunk lid system again.