Zero Point Calibration
- Zero point calibration procedures
- Check that all of the following conditions are met:
- The vehicle is parked on a level surface.
- No objects are placed on the front passenger seat.
- The front passenger seat belt buckle switch is OFF.
- Adjust the seat position according to the table below.
Adjustment Item Position Slide Direction Rearmost position Reclining Angle Upright position Headrest Height Lowest position Lifter Height Lowest position - Connect the Techstream to the DLC3.
- Turn the power switch ON (IG).
- Perform zero point calibration by following the prompts on the tester screen.
HINT:
- Refer to the Techstream operator's manual for further details.
- If the zero point calibration is performed when the calibration conditions are not satisfied, DTC B1797 is output.
- If the zero point calibration has failed, DTC B1797 is output.
- If After Exchange is selected before the previous ECU data are stored in the Techstream, the display screen returns to CONDITION SELECT ECU: Occupant Detect.
Item Procedure DTC Perform DTC check and repair Write error Replace front seat set (with occupant classification ECU and occupant detection sensor) Temperature Check value of THERMISTOR TEMP in ECU DATA LIST Pressure Check value of FILTERED PRESS in ECU DATA LIST Crash counter -
- Check that all of the following conditions are met: