DTC P060B: Internal Control Module A/D Processing Performance: Procedure
- READ OUTPUT DTC (DTC P060B)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear DTCs. Refer to DTC CHECK / CLEAR .
- Turn the engine switch to off and turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Wait for 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.
Result
Result Proceed to DTC is not output A DTC P060B is output B DTC P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D are output C
B → See step 3
C → See step 4
A → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
- REPLACE ECM. Refer to REMOVAL
- GO TO DTC (P0327, P0328, P032C, P032D, P0332, P0333, P033C and P033D). Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input