Installation [09/2015 - ]: Procedure

INSTALL NO. 1 BRAKE CONTROL POWER SUPPLY BRACKET

Install the 2 brackets with the 4 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTE:

Do not drop the brake control power supply. If the brake control power supply has been dropped replace the brake control power supply with a new one.

INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY

Connect the connector.

Install the brake control power supply with the 2 nuts.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)

INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH
(Refer to INSTALLATION [09/2015 - ] )
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
INSTALL BATTERY SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 13
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 14
CHECK AND CLEAR DTC
(Refer to DTC CHECK / CLEAR [09/2015 - ] )