Installation [09/2015 - ]: Procedure

INSTALL SKID CONTROL BUZZER ASSEMBLY

NOTE:

If the buzzer connector is connected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to install the buzzer according to the procedures below.

Connect the connector.

Attach the clamp and install the buzzer to the extension panel.

INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(Refer to INSTALLATION [09/2015 - ] )
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTE:
- Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] ).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
INSTALL BATTERY SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 13
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 14