Precaution [10/2015 - 11/2017]
- INITIALIZATION NOTE:
- Before replacing the ECM, refer to Registration.
Refer to REGISTRATION [10/2015 - 11/2017]
- Before replacing the ECM, store the heavy knock history. After replacement, write the heavy knock history to the new ECM.
Refer to REGISTRATION [10/2015 - ]
- Initialize the heavy knock history after replacing the piston rings.
Refer to INITIALIZATION [10/2015 - 10/2018]
- Perform Registration (VIN registration) after replacing the ECM.
Refer to REGISTRATION [10/2015 - ]
- Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transmission assembly, ECM or engine assembly.
Refer to INITIALIZATION [10/2015 - ]
- When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
System Name See Procedure Variable Gear Ratio Steering System Refer to INITIALIZATION [10/2015 - 11/2017] Parking Assist Monitor System Air Conditioning System
- Before replacing the ECM, refer to Registration.
- WHEN USING TECHSTREAM WARNING:
Observe the following items for safety reasons:
- Before using the Techstream, read the instruction manual.
- Prevent the Techstream cable from being caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
- When driving the vehicle for testing purposes using the Techstream, 2 persons are required. One to drive the vehicle, and another to operate the Techstream.