Communication Circuit Wiring Repair

Fig 1: Special Tool(s)

Courtesy of FORD MOTOR CO.

Disconnect the battery ground cable. For additional information, see BATTERY DISCONNECT .
Strip the wires.

Fig 2: Striping Wires
Courtesy of FORD MOTOR CO.

NOTE: Use rosin core mildly activated (RMA) solder, not acid core solder.

Fig 3: Soldering Wires

Courtesy of FORD MOTOR CO.

Solder the wires.
1. Install the heat shrink tube.
2. Twist the wires together.
3. Solder the wires together.

NOTE: Wait for the solder to cool before moving the wires.

Fig 4: Bending Wires Straight

Courtesy of FORD MOTOR CO.

Bend the wires back in a straight line.
Position the (A) heat shrink tube over the (B) wire repair.
- Overlap the heat shrink tube on both wires.
Fig 5: Positioning Heat Shrink Tubing
Courtesy of FORD MOTOR CO.
Use the heat gun to heat the repaired area until adhesive flows out both ends of the heat shrink tube.

Fig 6: Heating Heat Shrink Tubing
Courtesy of FORD MOTOR CO.
Reconnect the battery ground cable.