Removal and Installation
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the front brake disc. For additional information, refer to FRONT DISC BRAKE .
- Disconnect the wheel speed sensor electrical connector.
- Remove the 3 wheel speed sensor harness retainers.
- Remove the 2 wheel speed sensor harness pin-type retainers.
- Remove the wheel speed sensor bolt.
- To install, tighten to 17 Nm (13 lb-ft).
- Remove the wheel speed sensor and the harness.
- To install, reverse the removal procedure.