Anti-Lock Control DTCS
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTCS | Source | Description | Perform Test |
|---|---|---|---|
| B1342 | ABS Module | ECU is Defective | CLEAR the DTCs. RETRIEVE the DTCs. REPEAT the self-test. If DTC B1342 is retrieved again, INSTALL a new ABS module. REFER to ANTI-LOCK BRAKE SYSTEM (ABS) MODULE . REPEAT the self-test. |
| B1484 | ABS Module | Brake Pedal Input Open Circuit | Go to PINPOINT TEST D . |
| B1596 | ABS Module | Service Continuous Codes | TURN the ignition switch from OFF to ON. REPEAT the ABS self-test. If any DTCs are retrieved, REFER to the ANTI-LOCK BRAKE SYSTEM (ABS) MODULE DIAGNOSTIC TROUBLE CODE (DTC) INDEX . If no DTCs are retrieved, CARRY OUT a drive test above 15 km/h (9 mph), then REFER to the SYMPTOM CHART . |
| B1676 | ABS Module | Battery Voltage Out of Range | Go to PINPOINT TEST E . |
| C1145 | ABS Module | RF Anti-Lock Brake Sensor Input Circuit Failure | Go to PINPOINT TEST B . |
| C1155 | ABS Module | LF Anti-Lock Brake Sensor Input Circuit Failure | Go to PINPOINT TEST B . |
| C1165 | ABS Module | RR Anti-Lock Brake Sensor Input Circuit Failure | Go to PINPOINT TEST B . |
| C1175 | ABS Module | LR Anti-Lock Brake Sensor Input Circuit Failure | Go to PINPOINT TEST B . |
| C1222 | ABS Module | Mismatched Wheels or Damaged Wheel Speed Sensor Ring | Make sure the tires are the same size and correctly inflated. INSPECT the wheel speed sensor rings. CLEAR the DTCs. TEST drive the vehicle. REPEAT the self-test. |
| C1266 | ABS Module | ABS Valve Power Relay Circuit Failure | Go to PINPOINT TEST J . |
| C1296 | ABS Module | LF Anti-Lock Brake Sensor Input Signal Missing | Go to PINPOINT TEST C . |
| C1297 | ABS Module | RF Anti-Lock Brake Sensor Input Signal Missing | Go to PINPOINT TEST C . |
| C1298 | ABS Module | RR Anti-Lock Brake Sensor Input Signal Missing | Go to PINPOINT TEST C . |
| C1299 | ABS Module | LR Anti-Lock Brake Sensor Input Signal Missing | Go to PINPOINT TEST C . |
| C1300 | ABS Module | ABS Hydraulic Pump Motor Circuit Failure | Go to PINPOINT TEST A . |
| C1805 | ABS Module | PCM and ABS Modules Do Not Match | CHECK the part numbers. INSTALL the correct module. REFER to ELECTRONIC ENGINE CONTROLS . |
| C2775 | ABS Module | TC ON/OFF Switch Stuck Failure | Go to PINPOINT TEST H . |
| U0073 | Instrument Cluster | Control Module Communication Bus Off | REFER to MODULE COMMUNICATIONS NETWORK . |
| U1900 | PCM | CAN Communication Bus Fault -Receive Error | REFER to MODULE COMMUNICATIONS NETWORK . |
| U2023 | Instrument Cluster | Fault Received From External Node | REFER to MODULE COMMUNICATIONS NETWORK . |